Allied Telesis AT-8100 Series - Manual (Page 1305)

AT-8100 Switch Command Line User’s Guide
1305
SHOW LLDP LOCAL-INFO INTERFACE
Syntax
show lldp local-info [interface port ]
Parameters
port
Specifies a port, You can specify more than one port at a time with
this command. Omitting this parameter displays the LLDP
information for all the ports.
Mode
Privileged Exec mode
Description
Use this command to display the LLDP and LLDP-MED TLVs that the local
ports are actively transmitting to their LLDP-compatible neighbors. Ports
that have not been activated with “LLDP TRANSMIT RECEIVE” on
page 1283 or that have not established links with their LLDP counterparts
cannot be displayed with this command. See Figure 218 and Figure 219
on page 1306.
Figure 218. SHOW LLDP LOCAL-INFO INTERFACE Command
LLDP Local Information:
Chassis ID Type .................. MAC address
Chassis ID ....................... 0015.77d8.4360
Port ID Type ..................... Port component
Port ID .......................... 25
TTL .............................. 120 (secs)
Port Description ................. Port_25
System Name ...................... [zero length]
System Description ............... AT-FS970M/24C
System Description ............... AT-8100S/24
System Description ............... AT-9000/28
System Capabilities
- Supported .. Bridge, Router
- Enabled .... Bridge, Router
Management Addresses ............. 0.0.0.0
Port VLAN ID (PVID) .............. 1
Port & Protocol VLAN
- Supported . No
- Enabled ... No
- VIDs ...... 0
VLAN Names ........................ Default_VLAN
Protocol IDs .....................
MAC/PHY Auto-negotiation .......... Supported / Enabled
Advertised Capability ....... 1000BaseTFD, 100BaseTXFD, 100BaseTX,