Allied Telesis AT-8100 Series - Manual (Page 225)

AT-8100 Switch Command Line User’s Guide
225
NO SNMP TRAP LINK-STATUS
Syntax
no snmp trap link-status
Parameter
None
Mode
Port Interface mode
Description
Use this command to deactivate SNMP link traps on the ports of the
switch. The switch does not send traps when a port on which link trap is
disabled experiences a change in its link state (i.e., goes up or down).
Confirmation Command
“SHOW INTERFACE” on page 234
Example
This example deactivates link traps on ports 18 and 23:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.18,port1.0.23
awplus(config-if)# no snmp trap link-status