Allied Telesis AT-8100 Series - Manual (Page 1407)

AT-8100 Switch Command Line User’s Guide
1407
SERVICE TELNET
Syntax
service telnet
Parameters
None
Mode
Global Configuration mode
Description
Use this command to enable the Telnet server so that you can remotely
manage the switch with a Telnet application protocol. The default setting
for the Telnet server is enabled.
Note
The switch must have a management IP address for remote Telnet
management. For background information, refer to Chapter 13,
“IPv4 and IPv6 Management Addresses” on page 299.
Confirmation Command
“SHOW TELNET” on page 1408
Example
This example enables the Telnet server:
awplus> enable
awplus# configure terminal
awplus(config)# service telnet