Allied Telesis AT-8100 Series User Manual
Page 1092
Chapter 72: 802.1x Port-based Network Access Control Commands
1092
“AUTH-MAC REAUTH-
RELEARNING” on page 1107
Port Interface
Sets the MAC address learning of the
supplicant (client device) to relearning
for re-authentication on the interface
specified in the Interface command
mode.
“DOT1X CONTROL-DIRECTION” on
page 1108
Port Interface
Sets the direction of the filter for the
unauthorized interface.
Global
Configuration
Controls the action of the switch to
EAP packets when 802.1x
authentication is disabled on the
switch.
“DOT1X INITIALIZE INTERFACE” on
page 1112
Port Interface
Forces authenticator ports into the
unauthorized state and initializes
authentication.
“DOT1X MAX-REAUTH-REQ” on
page 1113
Port Interface
Specifies the maximum number of
times authenticator ports transmit
EAP Request packets to supplicants
before timing out authentication
sessions.
“DOT1X PORT-CONTROL AUTO” on
page 1114
Port Interface
Sets ports to the authenticator role.
“DOT1X PORT-CONTROL FORCE-
AUTHORIZED” on page 1115
Port Interface
Configures ports to the 802.1x port-
based authenticator role in the forced-
authorized state.
“DOT1X PORT-CONTROL FORCE-
UNAUTHORIZED” on page 1116
Port Interface
Configures ports to the 802.1x port-
based authenticator role in the forced-
unauthorized state.
“DOT1X PORT-CONTROL
SUPPLICANT” on page 1117
Port Interface
Designates ports as supplicant ports.
“DOT1X SUPPLICANT-PARAMS
AUTH-PERIOD” on page 1118
Port Interface
Specifies the time period in seconds
that supplicant ports wait for replies
from authenticators after sending
EAP-Response frames.
“DOT1X SUPPLICANT-PARAMS
HELD-PERIOD” on page 1119
Port Interface
Specifies the amount of time in
seconds a supplicant waits to re-
authenticate after an authentication
attempt has failed.
Table 115. 802.1x Port-based Network Access Control Commands (Continued)
Command
Mode
Description