Allied Telesis AT-8100 Series - Manual (Page 272)

Chapter 12: Power Over Ethernet Commands
272
NO POWER-INLINE ALLOW-LEGACY
Syntax
no power-inline allow-legacy
Parameters
None
Mode
Port Interface mode
Description
Use this command to configure the ports to deny power to legacy PDs.
Legacy PDs are PoE devices that were designed before the IEEE 802.3af
and IEEE 802.3at PoE standards were finalized. This is the default setting
for the ports.
Confirmation Command
“SHOW POWER-INLINE INTERFACE DETAIL” on page 294
Example
This example configures ports 1 to 12 to deny power to legacy PDs:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.1-port1.0.12
awplus(config-if)# no power-inline allow-legacy