Allied Telesis AT-8100 Series - Manual (Page 47)

47
Preface
This is the command line management guide for the AT-8100 Series of
Gigabit Ethernet Switches. The instructions in this guide explain how to
start a management session and how to use the commands in the
AlliedWare Plus command line interface to view and configure the features
of the switch.
For hardware installation instructions, refer to the AT-8100L and AT-8100S
Series Gigabit Ethernet Switches Installation Guide for installing the
switches as stand-alone units and the AT-8100S Fast Ethernet Switch
Stacking Installation Guide for installing the switches as a unified, virtual
switch.
This preface contains the following sections:
 “Document Conventions” on page 48
 “Where to Find Web-based Guides” on page 49
 “Contacting Allied Telesis” on page 50
Caution
The customer, re-seller, sub-contractor, distributor, software
developer or any buyer of an Allied Telesis “ATI” product known as
“customer”, hereby agrees to have all licenses required by any
governmental agency and to comply with all applicable laws and
regulations in its performance under this Agreement, including
export control, maintained by U.S. Commerce Department’s Bureau
of Industry and Security (BIS) and the U.S. Treasury Department’s
Office of Foreign Assets Control (OFAC), international boycotts
regulations and all anti-corruption laws, including the U.S. Foreign
Corrupt Practices Act (FCPA). The customer understands that U.S.
Government authorization may be required to export the software,
commodity or technology, or to re-export or re-transfer to a third
country, another end-user or another end-use. The customer agrees
to assume all such obligations.