Allied Telesis AT-8100 Series - Manual (Page 1741)

AT-8100 Switch Command Line User’s Guide
1741
Examples
The following example maps a DSCP value of 46 to egress queue 7 on
ingress port 1.0.24. The DSCP value is mapped to queue 7:
awplus> enable
awplus# configure terminal
awplus(config)# mls qos enable
awplus(config)# class-map trustdscp
awplus(config-cmap)# exit
awplus(config)# policy-map pmap1
awplus(config-pmap)# class trustdscp
awplus(config-pmap-c)# trust dscp
awplus(config-pmap-c)# exit
awplus(config-pmap)# exit
awplus(config)# interface port1.0.24
awplus(config-if)# service-policy input pmap1
awplus(config-if)# exit
awplus(config)# mls qos map dscp-queue 46 to 7
This example restores the default mappings of the DSCP priorities to the
egress queues on port 3:
awplus> enable
awplus# configure terminal
awplus(config-if)# no mls qos map dscp-queue