Timers basic, Timers basic 3 – Allied Telesis AT-8100 Series User Manual
Page 1903
AT-8100 Switch Command Line User’s Guide
1903
TIMERS BASIC
Syntax
timers basic update
update
timeout
timeout
garbage
garbage
Parameters
update
Specifies the interval, in seconds, that routing updates are
transmitted. The range is 5 to 2,147,483,647 seconds. The default
value is 30 seconds.
timeout
Specifies the routing information timeout timer in seconds. The
range is 5 to 2,147,483,647 seconds. After this interval has
elapsed, and no updates from a route are received, the route is
declared invalid. The default value is 180 seconds.
garbage
Specifies the routing garbage-collection timer in seconds. After this
interval has elapsed, and no updates from a route are received, the
route is removed from the routing table. The range is 5 to
2,147,483,647 seconds. The default value is 120 seconds.
Mode
Routing Configuration mode
Description
Use this command to adjust the timers that RIP uses to minimize
disruptions to end users of the network in the situation where quick
recovery is necessary. You can change three timers with this command:
Interval that a RIP packet is sent
Interval that a route is declared invalid
Interval that the invalid route is removed from the routing table
All the routing devices in the network must have the same timers to ensure
the smooth operation of RIP throughout the network.
Confirmation Command