Allied Telesis AT-8100 Series - Manual (Page 339)

AT-8100 Switch Command Line User’s Guide
339
Activating the SNTP Client and Specifying the IP Address of an NTP or
SNTP Server
To activate the SNTP client on the switch and to specify the IP address of
an NTP or SNTP server, use the NTP PEER command in the Global
Configuration mode. You can specify the IP address of only one server.
This example of the command specifies 1.77.122.54 as the IP address of
the server:
awplus> enable
awplus# configure terminal
awplus(config)# ntp peer 1.77.122.54
To display the date and time, use the SHOW CLOCK command in the
User Exec and Privileged Exec modes.
awplus# show clock