Allied Telesis AT-8100 Series - Manual (Page 1325)

AT-8100 Switch Command Line User’s Guide
1325
Displaying the ARP Table
To display the ARP table on the switch, use the SHOW ARP command in
the User Exec mode or the Privileged Exec mode. Here is the format of the
command:
awplus# show arp
An example is shown in Figure 226.
Figure 226. SHOW ARP Command
The fields are described in Table 140 on page 1332.
IP ARP
ARP Cache Timeout ......... 300 seconds
Total ARP Entries ......... 215
IP Address MAC Address Interface Port Type
-----------------------------------------------------------------
149.122.34.4
0006.5bb2.4421 vlan2 port1.0.2 Dynamic
149.122.34.12 00a0.d218.eea1 vlan2 port1.0.3 Dynamic
149.122.34.21 00a0.c357.3214 vlan2 port1.0.4 Dynamic
149.122.35.1 00a0.64b1.76a5 vlan8 port1.0.7 Dynamic