Allied Telesis AT-8100 Series - Manual (Page 101)

AT-8100 Switch Command Line User’s Guide
101
DO
Syntax
do command
Parameter
command
Specifies the Privileged Exec mode command to perform. Refer to
the Description for the list of supported commands.
Mode
Global Configuration mode
Description
Use this command to perform Privileged Exec mode commands from the
Global Configuration mode. You may use the command to perform some,
but not all, of the Privileged Exec mode commands. Here are the only
Privileged Exec mode commands that are supported with the DO
command:
 ERASE STARTUP-CONFIG
 PING
 REBOOT
 RELOAD
 SHOW INTERFACE
 SHOW INTERFACE STATUS
 SHOW IP IGMP
 SHOW IP IGMP HOSTLIST
 SHOW IP IGMP ROUTERLIST
 SHOW IP IGMP SNOOPING
 SHOW IP INTERFACE
 SHOW IP ROUTE
 SHOW IPV6 INTERFACE
 SHOW MAC ADDRESS-TABLE
 SHOW RUNNING-CONFIG
 SHOW SPANNING-TREE