Allied Telesis AT-8100 Series - Manual (Page 609)

609
Chapter 41
IGMP Snooping Commands
The IGMP snooping commands are summarized in Table 62 and are
described in detail within the chapter.
Table 62. Internet Group Management Protocol Snooping Commands
Command Mode Description
“CLEAR IP IGMP” on page 610 Privileged Exec Clears all IGMP group membership
records.
“IP IGMP LIMIT” on page 611 Global
Configuration Specifies the maximum number of
multicast addresses the switch is
allowed to learn.
“IP IGMP QUERIER-TIMEOUT” on
page 612 Global
Configuration Specifies the time period in seconds
used by the switch to identify inactive
host nodes and multicast routers.
“IP IGMP SNOOPING” on page 613 Global
Configuration Enables IGMP snooping on the
switch.
“IP IGMP SNOOPING FLOOD-
UNKNOWN-MCAST” on page 614 Global
Configuration Disables the automatic suppression of
unknown multicast traffic.
“IP IGMP SNOOPING MROUTER” on
page 616 Global
Configuration Manually identifies the ports where
multicast routers are connected.
“IP IGMP STATUS” on page 617 Global
Configuration Specifies the IGMP host node
topology, of either single-host per port
or multiple-host per port.
“NO IP IGMP SNOOPING” on
page 618 Global
Configuration Disables IGMP snooping on the
switch.
“NO IP IGMP SNOOPING
MROUTER” on page 619 Global
Configuration Removes multicast router ports.
“SHOW IP IGMP SNOOPING” on
page 620 Privileged Exec Displays the parameter settings and
operational details of IGMP snooping.