Allied Telesis AT-8100 Series - Manual (Page 269)

269
Chapter 12
Power Over Ethernet Commands
The Power over Ethernet (PoE) commands are summarized in Table 23.
These commands are only supported on the PoE switches.
Table 23. Power over Ethernet Commands
Command Mode Description
“CLEAR POWER-INLINE
COUNTERS INTERFACE” on
page 271 Privileged Exec Clears the PoE event counters on the
ports.
“NO POWER-INLINE ALLOW-
LEGACY” on page 272 Port Interface Configures ports to deny power to
legacy powered devices (PDs).
“NO POWER-INLINE DESCRIPTION”
on page 273 Port Interface Deletes the PD descriptions.
“NO POWER-INLINE ENABLE” on
page 274 Port Interface Disables PoE on the ports.
“NO POWER-INLINE MAX” on
page 275 Port Interface Restores a port’s power limit to the
default value.
“NO POWER-INLINE PRIORITY” on
page 276 Port Interface Restores a port’s priority setting to the
default Low level.
“NO POWER-INLINE USAGE-
THRESHOLD” on page 277 Global
Configuration Resets the power usage threshold to
the default 80%.
“NO SERVICE POWER-INLINE” on
page 278 Global
Configuration Disables PoE on all of the ports on the
switch.
“NO SNMP-SERVER ENABLE TRAP
POWER-INLINE” on page 279 Global
Configuration Disables the SNMP power-inline trap.
“POWER-INLINE ALLOW-LEGACY”
on page 280 Port Interface Configures a port to support legacy
PDs.
“POWER-INLINE DESCRIPTION” on
page 281 Port Interface Adds a PD description to a port.
“POWER-INLINE ENABLE” on
page 282 Port Interface Enables PoE on a port.
“POWER-INLINE MAX” on page 283 Port Interface Specifies the power limit of a port.