Allied Telesis AT-8100 Series - Manual (Page 1194)

Chapter 75: SNMPv3 Commands
1194
SNMP-SERVER ENGINEID LOCAL
Syntax
snmp-server engineid local engine-id|default
Parameters
engine-id
Specifies the SNMPv3 engine ID. The value can be up to 32
characters.
default
Returns the SNMPv3 engine ID to the system-generated value.
Mode
Global Configuration mode
Description
Use this command to configure the SNMPv3 engine ID.
Note
Changing the SNMPv3 engine ID from its default value is not
recommended because the SNMP server on the switch may fail to
operate properly.
Confirmation Command
“SHOW SNMP-SERVER” on page 1188
Examples
This example sets the SNMPv3 engine ID to 89ab532d782:
awplus> enable
awplus# configure terminal
awplus(config)# snmp-server engineid local 89ab532d782
This example returns the SNMPv3 engine ID to the default setting:
awplus> enable
awplus# configure terminal
awplus(config)# snmp-server engineid local default