Allied Telesis AT-8100 Series - Manual (Page 1307)

AT-8100 Switch Command Line User’s Guide
1307
SHOW LLDP NEIGHBORS DETAIL
Syntax
show lldp neighbors detail [interface port ]
Parameters
port
Specifies a port. You can specify more than one port.
Mode
Privileged Exec mode
Description
Use this command to display the information the switch has gathered from
its LLDP and LLDP-MED neighbors. To display the information for all the
neighbors, do not include the INTERFACE parameter. See Figure 220 and
Figure 221 on page 1308.
Figure 220. SHOW LLDP NEIGHBORS DETAIL Command
LLDP Detailed Neighbor Information:
Neighbors table last updated 0 hrs 0 mins 20 secs ago
Chassis ID Type .................. MAC address
Chassis ID ....................... 0015.77d8.4360
Port ID Type ..................... Port component
Port ID .......................... port1.0.25
TTL .............................. 120 (secs)
Port Description ................. Port 25
System Name ...................... [zero length]
System Description ............... AT-FS970M/24C
System Description ............... AT-8100S/24
System Description ............... AT-9000/28SP
System Capabilities
- Supported .. Bridge, Router
- Enabled .... Bridge, Router
Management Addresses ............. 0.0.0.0
Port VLAN ID (PVID) .............. 1
Port & Protocol VLAN
- Supported . No
- Enabled ... No
- VIDs ...... 0
VLAN Names ....................... Default_VLAN
Protocol IDs .....................
MAC/PHY Auto-negotiation ......... Supported / Enabled
Advertised Capability ....... 1000BaseTFD, 100BaseTXFD, 100BaseTX,
10BaseTFD, 10BaseT
Operational MAU Type ........ 30 (1000BaseTFD)
Power Via MDI (PoE) .............. Not Supported