Allied Telesis AT-8100 Series - Manual (Page 1698)

Chapter 101: QoS Commands
1698
“MATCH TCP-FLAGS” on page 1726 Class Map Sets one or more TCP flags for a
class map.
“MATCH VLAN” on page 1728 Class Map Sets a VLAN ID for a class map.
“MLS QOS AGGREGATE-POLICE
SINGLE-RATE” on page 1729 Policy Map
Class mode Configures a single-rate policer for a
class map and creates a police
aggregator.
“MLS QOS AGGREGATE-POLICE
TWIN-RATE” on page 1732 Policy Map
Class mode Configures a twin-rate policer for a
class map and creates a police
aggregator.
“MLS QOS COS” on page 1735 Interface
Configuration Assigns a Class of Service (CoS)
user-priority value to untagged frames
that enter the specified interface.
“MLS QOS ENABLE” on page 1737 Global
Configuration Activates QoS on the switch. This
feature is disabled by default.
“MLS QOS MAP COS-QUEUE” on
page 1738 Global
Configuration Maps CoS priorities to egress queues.
“MLS QOS MAP DSCP-QUEUE” on
page 1740 Global
Configuration Maps DSCP priorities to egress
queues.
“MLS QOS MAP POLICED-DSCP” on
page 1742 Global
Configuration Maps an existing DSCP to a new
DSCP value.
“NO AUTO-QOS VOICE | TRUST
DSCP” on page 1744 Interface
Configuration Disables Auto-QoS support for a voice
VLAN and specifies CoS or DSCP
trusted traffic.
“NO MATCH ACCESS-GROUP” on
page 1746 Class Map
Mode Removes an ACL name or number
from a class map.
“NO MATCH PROTOCOL” on
page 1748 Class Map
Mode Removes an Ethernet format and a
protocol from a class map.
“NO MLS QOS AGGREGATE-
POLICE” on page 1750 Global
Configuration Removes an association between a
police aggregator and a class map.
“NO MLS QOS ENABLE” on
page 1751 Global
Configuration Disables QoS on the switch.
“NO POLICE AGGREGATE” on
page 1752 Policy Map
Class Disables a policer configured on a
class map.
“POLICE AGGREGATE” on
page 1753 Policy Map
Class Associates an aggregate name with a
class map.
Table 233. Quality of Service Commands (Continued)
Command Mode Description