Disabling mac address-based security on ports, Disabling mac address-based security on ports 3 – Allied Telesis AT-8100 Series User Manual

Page 1043

Text mode
Original mode

AT-8100 Switch Command Line User’s Guide

1043

Disabling MAC Address-based Security on Ports

To remove MAC address-based security from ports, use the NO
SWITCHPORT PORT-SECURITY command in the Port Interface mode.
This example of the command removes port security from port 23:

awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.23
awplus(config-if)# no switchport port-security

Note

To activate ports that were disabled by the shutdown intrusion
action, refer to “NO SHUTDOWN” on page 224.