Allied Telesis AT-8100 Series - Manual (Page 1742)

Chapter 101: QoS Commands
1742
MLS QOS MAP POLICED-DSCP
Syntax
mls qos map policed-dscp to <0 -
63>
Parameters
existing-dscp
Specifies the existing DSCP value.
new-dscp
Specifies the new DSCP value. The range is 0 to 63.
Mode
Global Configuration mode
Description
Use this command to configure the policed DSCP map. It maps the
existing value set for DSCP with the MLS QOS MAP DSCP-QUEUE
command to a new DSCP value. The map created with this command is
used when a policer action is set to policed-dscp-transmit with the
POLICE SINGLE-RATE ACTION or POLICE TWIN-RATE ACTION
commands.
To remove the new DSCP value, use the NO MLS QOS MAP POLICED-
DSCP command.
Note
This map will be used when a policer action is set to policed-dscp-
transmit.
Confirmation Command
“SHOW MLS QOS MAPS POLICED-DSCP” on page 1779
Examples
This example changes the DSCP value from 5 to 7:
awplus> enable
awplus# configure terminal
awplus(config)# mls qos map policed-dscp 5 to 7