Allied Telesis AT-8100 Series - Manual (Page 353)

AT-8100 Switch Command Line User’s Guide
353
SHOW NTP ASSOCIATIONS
Syntax
show ntp associations
Parameters
None
Mode
Privileged Exec mode
Description
Use this command to display the settings of the SNTP client. The
information the command displays is shown in Figure 79.
Figure 79. SHOW NTP ASSOCIATIONS Command
The information is described here:
Table 34. SHOW NTP ASSOCIATIONS Command
Parameter Description
Status The status of the SNTP client software on
the switch. The status can be either
enabled or disabled. If enabled, the switch
seeks its date and time from an NTP or
SNTP server. The default is disabled.
To enable the client, use “NTP PEER” on
page 350. To disable the client, refer to
“NO NTP PEER” on page 349.
Server The IP address of an NTP or SNTP
server. This value is set with “NTP PEER”
on page 350.
NTP Configuration:
Status ........................ Enabled
Server ........................ 192.168.20.27
UTC Offset .................... +02:00
Daylight Savings Time (DST) ... Enabled