Allied Telesis AT-8100 Series - Manual (Page 1738)

Chapter 101: QoS Commands
1738
MLS QOS MAP COS-QUEUE
Syntax
mls qos map cos-queue cos_priority to egress_queue
Parameters
cos_priority
Specifies a Class of Service (CoS) priority level of 0, the lowest
priority, through 7, the highest priority mapped to it. An egress
queue can have more than one priority level, but you can specify
only one priority level at a time with this command.
egress_queue
Specifies an egress queue number of 0 through 7. The lowest
priority queue is 0, and the highest queue is 7. You can specify
only one queue.
Mode
Global Configuration mode
Description
Use this command to map CoS values to port egress queues. An egress
queue can have more than one priority mapped to it, but you can assign
only one priority at a time with this command. For a list of the default
mappings between the CoS Priority and Queue, see Figure 267.
Figure 267. CoS Priority to CoS Queue Mapping
Use the NO form of this command, NO MLS QOS MAP COS-QUEUE, to
return the CoS priority on mappings to their default values.
COS-TO-QUEUE-MAP:
COS: 0 1 2 3 4 5 6 7
----------------------------
QUEUE: 2 0 1 3 4 5 6 7