Allied Telesis AT-8100 Series - Manual (Page 764)

Chapter 52: LACP Commands
764
PORT-CHANNEL LOAD-BALANCE
Syntax
port-channel load-balance src-mac|dst-mac|src-dst-mac|
src-ip|dst-ip|src-dst-ip
Parameters
src-mac
Specifies source MAC address as the load distribution method.
dst-mac
Specifies destination MAC address.
src-dst-mac
Specifies source address/destination MAC address.
src-ip
Specifies source IP address.
dst-ip
Specifies destination IP address.
src-dst-ip
Specifies source address/destination IP address.
Mode
LACP Port Trunk Interface mode
Description
Use this command to set the load distribution methods of aggregators. An
aggregator can have only one load distribution method. The load
distribution methods are the same as those for static port trunks described
in “Load Distribution Methods” on page 730.
To enter the LACP Port Trunk Interface mode, from the Global
Configuration mode, enter the INTERFACE PO command and the ID
number of the aggregator. For example, to enter the mode for the
aggregator that has the ID number 2, you enter:
awplus> enable
awplus# configure terminal
awplus(config)# interface po2