Allied Telesis AT-8100 Series - Manual (Page 204)

Chapter 10: Port Parameter Commands
204
“NO STORM-CONTROL” on
page 226 Port Interface Removes threshold limits for
broadcast, multicast, or unknown
unicast packets.
“POLARITY” on page 227 Port Interface Sets the MDI/MDI-X settings on
twisted pair ports.
“PURGE” on page 229 Port Interface Restores the default settings.
“RENEGOTIATE” on page 230 Port Interface Prompts ports that are using Auto-
Negotiation to renegotiate their
settings with the network devices.
“RESET” on page 231 Port Interface Performs software resets on the ports.
“SHOW FLOWCONTROL
INTERFACE” on page 232 Privileged Exec Displays the current settings for flow
control on the ports.
“SHOW INTERFACE” on page 234 Privileged Exec Displays port settings.
“SHOW INTERFACE BRIEF” on
page 238 Privileged Exec Displays administrative and link
statuses.
“SHOW INTERFACE STATUS” on
page 240 Privileged Exec Displays the speed and duplex mode
settings of the ports.
“SHOW PLATFORM TABLE PORT
COUNTERS” on page 242 Privileged Exec Displays packet statistics for the
individual ports.
“SHOW RUNNING-CONFIG
INTERFACE” on page 245 Privileged Exec Displays the settings of the specified
ports.
“SHOW STORM-CONTROL” on
page 246 Privileged Exec Displays threshold settings for
broadcast, multicast, and unknown
unicast packets.
“SHOW SYSTEM PLUGGABLE” on
page 248 Privileged Exec Displays information about the SFP
modules in the switch.
“SHOW SYSTEM PLUGGABLE
DETAIL” on page 249 Privileged Exec Displays information about the SFP
modules in the switch.
“SHUTDOWN” on page 250 Port Interface Disables ports to stop them from
forwarding network traffic.
“SNMP TRAP LINK-STATUS” on
page 251 Port Interface Activates link traps.
“SPEED” on page 252 Port Interface Manually sets port speed or activates
Auto-Negotiation.
Table 11. Port Parameter Commands (Continued)
Command Mode Description