Allied Telesis AT-8100 Series - Manual (Page 709)

AT-8100 Switch Command Line User’s Guide
709
SHOW LOG PERMANENT
Syntax
show log permanent
Parameters
None
Mode
Privileged Exec mode
Description
Use this command to display the messages in the permanent log. The
event messages are displayed from oldest to newest, one screen at a
time. To cancel the display, type ‘q’ for quit. An example of the log is
shown in Figure 136.
Figure 136. SHOW LOG PERMANENT Command
Table 80 on page 704 describes the columns in the log and Table 81 on
page 705 lists the modules and their abbreviations.
Example
The following example displays the messages in the permanent log:
awplus# show log permanent
. ]>:
-------------------------------------------------------------------------
2010 Jan 15 14:39:04 user.information awplus stp: Set Configuration succeeded
2010 Jan 15 14:39:04 user.information awplus stp: Set Configuration succeeded
2010 Jan 15 14:39:04 user.information awplus stp: Disabled Spanning Tree
2010 Jan 15 14:39:04 user.information awplus stp: Active protocol changed to STP