Allied Telesis AT-8100 Series - Manual (Page 1791)

AT-8100 Switch Command Line User’s Guide
1791
Enabling Policy-Based QSP
To enable QSP, use the STORM PROTECTION command. You enable
storm protection on a policy map. Storm protection is activated as soon as
a port is enabled which occurs before the port forwards frames. For more
information about this command, see “STORM-PROTECTION” on
page 1805.
The following example enables the QSP feature on a policy map called
“pmap2.”
Table 243. Enabling the Storm Protection Feature
Command Description
awplus> enable Enters the Privileged Executive mode from the User
Executive mode.
awplus# configure
terminal Enters the Global Configuration mode.
awplus(config)# mls
qos enable Activates the QoS feature on the switch.
awplus(config)#
policy-map pmap2 Creates a policy map called “pmap2” and enters the
Policy Map mode.
awplus(config-pmap)#
class cmap2 Associates an existing class map, called “cmap2,” to
policy map “pmap2” and enters the Policy Map Class
mode.
awplus(config-pmap-c)#
storm-protection Enables the QSP feature.