Allied Telesis AT-8100 Series - Manual (Page 509)

AT-8100 Switch Command Line User’s Guide
509
SHOW IP DHCP-RELAY
Syntax
show ip dhcp-relay [interface vlanid ]
Parameters
vlanid
Specifies a VLAN ID number, such as vlan1. You may specify only
one VLAN.
Mode
Privileged Exec mode
Description
Use this command to view the settings of the DHCP relay agent.
Figure 106 is an example of the information.
Figure 106. SHOW IP DHCP-RELAY Command
The fields are defined in Table 48.
Table 48. SHOW IP DHCP-RELAY Command
Field Definition
DHCP Relay
Service The enabled or disabled status of the agent. The
status is controlled with “SERVICE DHCP-
RELAY” on page 508 and “NO SERVICE DHCP-
RELAY” on page 507.
Maximum hop
count The hop count for discarding DHCP request
messages from clients. The parameter is
controlled with “IP DHCP-RELAY MAXHOPS” on
page 501.
DHCP Relay Service is enabled
List of Interfaces:
Maximum hop count is 10
Maximum DHCP message length is 576
Insertion of Relay Agent Option is disabled
Checking if Relay Agent Option is disabled
Relay Information policy is to replace existing relay
agent information.
List of servers: 149.187.132.21, 149.187.132.56