Allied Telesis AT-8100 Series - Manual (Page 1705)

AT-8100 Switch Command Line User’s Guide
1705
CLASS
Syntax
class name|default
Parameters
name
Indicates the name of a class map.
default
Indicates the class-map default name.
Mode
Policy Map Configuration mode
Description
Use this command to associate an existing class map to a policy map and
enter the Policy Map Class Configuration mode to configure the class
map. To create a class map, see “CLASS-MAP” on page 1707.
Use the no form of this command, NO CLASS, to delete an association
between a policy map and a class map.
Confirmation Commands
“SHOW POLICY-MAP” on page 1767
“SHOW RUNNING-CONFIG” on page 170
Examples
The following example creates a policy map called “pmap1,” then
associates a class map called “cmap5” to policy map “pmap1” and enters
the Policy Map Class Configuration mode:
awplus> enable
awplus# configure terminal
awplus(config)# policy-map pmap1
awplus(config-pmap)# class cmap5
awplus(config-pmap-c)#