No ip address, No ip address 1 – Allied Telesis AT-8100 Series User Manual
Page 1841
AT-8100 Switch Command Line User’s Guide
1841
NO IP ADDRESS
Syntax
no ip address
Parameters
None
Mode
VLAN Interface mode
Description
Use this command to delete IPv4 routing interfaces with static IP
addresses from the switch. You may delete only one routing interface at a
time with this command. To delete routing interfaces that have dynamic IP
addresses from a DHCP server, refer to “NO IP ADDRESS DHCP” on
page 1843. You must perform this command from the VLAN Interface
modes of the VLANs in which the routing interfaces reside.
Please review the following guidelines before deleting routing interfaces:
Deleting a routing interface from a VLAN that has static routes also
deletes the static routes.
Deleting a routing interface from a VLAN that has RIP also deletes
RIP from the VLAN.
If you are remotely managing the switch with Telnet or SSH and
delete the routing interface through which you are managing the
device, your management session is interrupted. You have to
manage the switch locally through the Console port if you delete all
of the routing interfaces.
Deleting a routing interface may stop the switch from performing
one or more of the management functions listed in Table 27 on
page 300.
Confirmation Command