Lldp management-address, Lldp management-address 9 – Allied Telesis AT-8100 Series User Manual
Page 1269
AT-8100 Switch Command Line User’s Guide
1269
LLDP MANAGEMENT-ADDRESS
Syntax
lldp management-address
ipaddress
Parameters
ipaddress
Specifies an IP address.
Mode
Port Interface mode
Description
Use this command to replace the default management IP address TLV of
a port. The management IP address TLV is optional. A port must be
configured to transmit it.
A port can have one of two possible default values for the management IP
address TLV. The default value depends on whether a port is a member of
the same VLAN as the management IP address, if present. Here are the
possible default values for a port:
A port that belongs to the same VLAN as the management IP
address uses the address as its TLV default value.
A port that belongs to a VLAN that does not have a management
IP address, either because no address has been assigned to the
switch or it is assigned to a different VLAN, uses the MAC address
of the switch as its default value for this TLV.
A port that belongs to more than one VLAN uses the management
IP address as its default value if the address is assigned to its
lowest numbered VLAN. Otherwise, it uses the switch’s MAC
address.
To return a port’s management IP address TLV to the default value, use
the NO form of this command.
Confirmation Command