Allied Telesis AT-8100 Series - Manual (Page 1692)

Chapter 100: Quality of Service (QoS)
1692
Displaying a
Policy Map
To display the contents of a policy map, use the SHOW POLICY-MAP
command in the Privileged Exec mode. Here is the command syntax
followed by an example display.
This example displays the settings of a policy map called “pmap4:'
awplus# show policy-map pmap4
Figure 260. SHOW POLICY-MAP command
Displaying
Aggregate
Policers
To display the settings of configured aggregate policers configured on the
switch, use the SHOW MLS QOS AGGREGATE-POLICER command in
the Privileged Exec mode. For a full command description, see “SHOW
MLS QOS AGGREGRATE-POLICER” on page 1668.
This example displays the contents of the aggregate policer, called ap2:
awplus# show mls qos aggregate-policer ap2
Figure 261. SHOW MLS QOS AGGREGATE-POLICER Command
Displaying QoS
Scheduling
Information
To display the scheduling methods of a port, use the SHOW MLS QOS
INTERFACE command. In addition, the assignments of weights to egress
queues for weighted round robin scheduling are displayed. The command
syntax is:
show mls qos interface port
Figure 262 on page 1693 provides an example of a port set to strict
priority.
POLICY-MAP-NAME: pmap4
Description: video traffic
State: attached
Default class-map action: permit
CLASS-MAP-NAME: cmap1
CLASS-MAP-NAME: default
AGGREGATE-POLICER-NAME: ap2
Policer single-rate action drop-red:
average rate (125 kbps) minimum burst (12000 B) maximum burst (17000 B)