Allied Telesis AT-8100 Series - Manual (Page 278)

Chapter 12: Power Over Ethernet Commands
278
NO SERVICE POWER-INLINE
Syntax
no service power-inline
Parameters
None
Mode
Global Configuration mode
Description
Use this command to disable PoE on the switch. The ports do not transmit
power to the PDs when PoE is disabled, but they do forward network
traffic. The default setting for PoE is enabled.
When performed on the master switches of a stack, the command
disables PoE on the ports on all of the PoE switches in the stack.
Confirmation Commands
“SHOW POWER-INLINE” on page 288
“SHOW POWER-INLINE INTERFACE” on page 293
“SHOW POWER-INLINE INTERFACE DETAIL” on page 294
Example
This example disables PoE on the switch:
awplus> enable
awplus# configure terminal
awplus(config)# no service power-inline