Estack command-switch – Allied Telesis AT-8100 Series User Manual
Page 439
AT-8100 Switch Command Line User’s Guide
439
ESTACK COMMAND-SWITCH
Syntax
estack command-switch
Parameter
None
Mode
Global Configuration mode
Description
Use this command to set the enhanced stacking mode on the
switch to the command mode. This command has the following
guidelines:
Enhanced stacking must be activated on the switch. To activate
enhanced stacking, refer to “ESTACK RUN” on page 440.
A switch that is a member of an active enhanced stack cannot be
changed to the command mode. You must first disable enhanced
stacking on the current command switch in the stack.
You cannot use this command on a switch accessed through
enhanced stacking. This command can only be used from a local
or remote management session of the switch.
Confirmation Command
Example
This example activates enhanced stacking on the switch and sets the
stacking status to command mode:
awplus> enable
awplus# configure terminal
awplus(config)# estack run
awplus(config)# estack command-switch