Allied Telesis AT-8100 Series - Manual (Page 1701)

AT-8100 Switch Command Line User’s Guide
1701
AUTO-QOS
Syntax
auto-qos [voice < VLANID > |trust dscp]
Parameters
voice
Specifies a VLAN ID for voice VLAN support. Enter a value
between 1 and 4094.
trust dscp
Specifies DSCP traffic is trusted.
Mode
Interface Configuration mode
Description
Use this command to enable Auto-QoS support for a voice VLAN ID and
optionally specify to trust DSCP (instead of CoS) ingress traffic on a port.
You can also use this command to support either a voice VLAN or specify
to trust DSCP.
Use the no form of this command, NO AUTO-QOS VOICE | TRUST DSCP
to disable Auto-QoS, remove a voice VLAN ID, and remove DSCP as
trusted ingress traffic. See “NO AUTO-QOS VOICE | TRUST DSCP” on
page 1744.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 170
Examples
In the following example, VLAN 100 becomes the voice VLAN on port
1.0.1, and CoS is trusted on traffic ingressing onto this port:
awplus> enable
awplus# configure terminal
awplus(config-if)# interface port1.0.1
awplus(config)# auto-qos voice 100