Allied Telesis AT-8100 Series - Manual (Page 1246)

Chapter 78: LLDP and LLDP-MED
1246
3. Move to the Port Interface mode of the ports to which the entry is to be
assigned. (A coordinate location entry can be applied to more than one
port.)
4. Use the LLDP LOCATION command in the Port Interface mode to
attach the location entry to the ports.
5. Use the LLDP MED-TLV-SELECT command in the Port Interface
mode to configure the ports to send the TLV in their advertisements.
Here is an example of how to create a coordinate location entry and apply
it to a port. The specifications of the entry are:
ID number: 16
Latitude: 37.29153547
Longitude: --121.91528320
Datum: nad83-navd
Altitude: 10.25
meters
The example is assigned to port 15.
The first series of commands creates the coordinate location entry.
alt-resolution Altitude resolution as number of valid
bits. The range is 0 to 30 bits.
datum nad83-mllw|nad83-
navd|
wgs84 The geodetic system (or datum) of the
coordinates. The selections are:
 nad83-mllw - Mean lower low water
datum 1983
 nad83-navd - North American
vertical datum 1983
 wgs84 - World Geodetic System
1984
Table 127. LLDP-MED Coordinate Location Entry Parameters
Parameter Value
awplus> enable Enter the Privileged Executive
mode from the User Executive
mode.
awplus# configure terminal Enter the Global Configuration
mode.