Allied Telesis AT-8100 Series - Manual (Page 179)

AT-8100 Switch Command Line User’s Guide
179
SNMP-SERVER LOCATION
Syntax
snmp-server location location
Parameters
location
Specifies the location of the switch. The location can be up to 255
alphanumeric characters. Spaces and special characters are
allowed.
Mode
Global Configuration mode
Description
Use this command to add location information to the switch.
To remove the current location information without adding new
information, use the NO form of this command.
Confirmation Command
“SHOW SYSTEM” on page 173
Examples
This example adds the location “Bldg5_fl2_rm201a” to the switch:
awplus> enable
awplus# configure terminal
awplus(config)# snmp-server location Bldg5_fl2_rm201a
This example removes the current location information:
awplus> enable
awplus# configure terminal
awplus(config)# no snmp-server location