Allied Telesis AT-8100 Series - Manual (Page 1601)

AT-8100 Switch Command Line User’s Guide
1601
dst_mac_address
Specifies the destination MAC address of the ingress packets.
Choose from the following options:
any: Matches any destination MAC address.
dst_mac_address: Specifies the destination MAC address of the
packets. The address must be entered in hexadecimal in this
format:
xx:xx:xx:xx:xx:xx or xxxx.xxxx.xxxx
dst_mac_mask
Specifies the destination MAC address mask. Enter the mask in
the following format:
xx:xx:xx:xx:xx:xx or xxxx.xxxx.xxxx
Assign the “x” variable a value of either “0” or “F.” Specify “0” to
indicate the parts of the MAC address the ACL is to filter. Specify
“F” for parts of the MAC address the ACL should ignore.
vlan
Indicates a VLAN identifier. Specify a VLAN if you want the ACL to
filter tagged packets. Omit a VLAN if you want the ACL to filter
untagged packets. Specify a value between 1 and 4094. You can
enter only one VID.
Mode
IP ACL mode
Description
Use this command to create Named IP ACLs that identify traffic flows
based on source and destination MAC addresses.
Confirmation Commands
“SHOW ACCESS-LIST” on page 1641 and “SHOW INTERFACE
ACCESS-GROUP” on page 1643