Allied Telesis AT-8100 Series - Manual (Page 1703)

AT-8100 Switch Command Line User’s Guide
1703
AUTO-QOS-MED
Syntax
auto-qos-med [voice < VLANID > |trust dscp]
Parameters
voice
Specifies a VLAN ID for voice VLAN support. Enter a value
between 1 and 4094.
trust dscp
Specifies DSCP traffic is trusted.
Mode
Global Configuration mode
Description
Use this command to enable Auto-QoS-MED support for a voice VLAN ID
and specify to optionally trust DSCP (instead of CoS) ingress traffic on a
port. You can also use this command to support either a voice VLAN or
specify to trust DSCP.
Use the no form of this command, NO AUTO-QOS VOICE | TRUST DSCP
to disable Auto-QoS, remove a voice VLAN, and remove trusted DSCP
traffic. See “NO AUTO-QOS VOICE | TRUST DSCP” on page 1744.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 170
Examples
In the following example, VLAN 100 becomes the voice VLAN on port
1.0.8, and CoS is trusted on traffic ingressing onto this port:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.8
awplus(config-if)# auto-qos-med voice 100