Allied Telesis AT-8100 Series - Manual (Page 273)

AT-8100 Switch Command Line User’s Guide
273
NO POWER-INLINE DESCRIPTION
Syntax
no power-inline description
Parameters
None
Mode
Port Interface mode
Description
Use this command to delete PD descriptions from the ports.
Confirmation Commands
“SHOW POWER-INLINE” on page 288
“SHOW POWER-INLINE INTERFACE” on page 293
“SHOW POWER-INLINE INTERFACE DETAIL” on page 294
Example
The following example deletes the PD description from port 5:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.5
awplus(config-if)# no power-inline description