Allied Telesis AT-8100 Series - Manual (Page 371)

AT-8100 Switch Command Line User’s Guide
371
IP DOMAIN-LOOKUP
Syntax
ip domain-lookup
Parameters
None
Mode
Global Configuration mode
Description
Use this command to enable the DNS client on the switch. The command
allows you to use domain names instead of IP addresses in commands.
The DNS client resolves a domain name into an IP address by sending a
DNS query to the DNS server specified with the IP NAME-SERVER
command.
The DNS client is enabled by default. However, it does not attempt DNS
queries unless at least one DNS server is configured.
To disable the DNS client on the switch, use the NO IP DOMAIN-LOOKUP
command.
Example
The following example enables the DNS client on the switch:
awplus> enable
awplus# configure terminal
awplus(config)# ip domain-lookup
The following command disables the DNS client on the switch:
awplus> enable
awplus# configure terminal
awplus(config)# no ip domain-lookup