Allied Telesis AT-8100 Series - Manual (Page 145)

AT-8100 Switch Command Line User’s Guide
145
BANNER EXEC
Syntax
banner exec
Parameters
None
Mode
Global Configuration mode
Description
Use this command to create a banner for the User Exec and Privilege
Exec modes. The message is displayed above the command line prompt
when you log on or clear the screen with the CLEAR SCREEN command,
in local, Telnet, and SSH management sessions.
After you enter the command, the “Type CTRL/D to finish” prompt is
displayed. Enter a banner message of up to 256 characters. Spaces and
special characters are allowed. When you are finished, press CTRL D.
To remove the banner, use the NO version of this command, NO BANNER
EXEC.
Note
Web browser management sessions do not display this banner.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 170
Examples
This example creates the banner “Production Switch 1P” for the User Exec
and Privileged Exec modes:
awplus> enable
awplus# configure terminal
awplus(config)# banner exec
Type CNTL/D to finish
Production Switch 1P