Allied Telesis AT-8100 Series - Manual (Page 294)

Chapter 12: Power Over Ethernet Commands
294
SHOW POWER-INLINE INTERFACE DETAIL
Syntax
show power-inline interface port detail
Parameter
port
Specifies a port. You can display more than one port at a time.
Mode
Privileged Exec mode
Description
Use this command to display additional information about the ports. An
example is shown in Figure 67.
Figure 67. SHOW POWER-INLINE INTERFACE DETAIL Command
The fields are described in Table 26.
Interface port1.0.1
Powered device type: Desk Phone #1
PoE admin enabled
Priority Low
Detection status: Powered
Current power consumption: 00 mW
Powered device class: 1
Power allocated: 5000 mW (from configuration)
Detection of legacy devices is disabled
Table 26. SHOW POWER-INLINE INTERFACE DETAIL Command
Field Description
Interface The port number.
Powered device
type The PD description. The description is set with
“POWER-INLINE DESCRIPTION” on page 281.