Allied Telesis AT-8100 Series - Manual (Page 1086)

Chapter 71: 802.1x Port-based Network Access Control
1086
Note
The management software does not have a separate SHOW
command for displaying the settings of supplicant ports. Instead,
use “SHOW RUNNING-CONFIG INTERFACE” on page 245.
Removing Ports
from the
Supplicant Role
The command for removing ports from the supplicant role and returning
them to the none role is the NO DOT1X PORT-CONTROL SUPPLICANT
command in the Port Interface mode. This example of the command
returns ports 1.0.4 and 1.0.5 to the none role from the supplicant role:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.4,port1.0.5
awplus(config-if)# no dot1x port-control supplicant
Note
Ports lose their supplicant parameter settings when returned to the
none role.