Snmp-server host, Snmp-server host 4 – Allied Telesis AT-8100 Series User Manual
Page 1174
Chapter 74: SNMPv1 and SNMPv2c Commands
1174
SNMP-SERVER HOST
Syntax
snmp-server host
ipaddress
traps|informs version 1|2c
community
Parameters
ipaddress
Specifies the IPv4 or IPv6 address of a network device to receive
trap or inform messages from the switch.
traps|informs
Specifies the type of messages.
1|2c
Specifies the format of the traps sent by the switch. For trap
messages, the format can be SNMPv1 (1) or SNMPv2c (2c). For
inform messages, the format must be SNMPv2c (2c).
community
Specifies an SNMP community string. This parameter is case
sensitive.
Mode
Global Configuration mode
Description
Use this command to specify IP addresses of network devices to receive
trap and inform messages from the switch. A community string can have
up to eight IP addresses of trap and inform receivers.
SNMP must be enabled on the switch for you to add trap and inform
receivers to community strings. To enable SNMP, refer to “SHOW SNMP-
SERVER VIEW” on page 1169
Confirmation Command