Allied Telesis AT-8100 Series - Manual (Page 1312)

Chapter 79: LLDP and LLDP-MED Commands
1312
SHOW LLDP NEIGHBORS INTERFACE
Syntax
show lldp neighbors interface [ port ]
Parameters
port
Specifies a port. You can specify more than one port at a time with
this command.
Mode
Privileged Exec mode
Description
Use this command to view a summary of the information gathered by the
switch from its LLDP and LLDP-MED neighbors. To display the
information from all the neighbors, do not include a port number.
Figure 222. SHOW LLDP NEIGHBORS INTERFACE Command
The information is explained in Table 134.
Total number of neighbors on these ports .... 1
System Capability Codes:
O = Other P = Repeater B = Bridge W = WLAN Access Point
R = Router T = Telephone C = DOCSIS Cable Device S = Station Only
LLDP-MED Device Class and Power Source Codes:
1 = Class I 3 = Class III PSE = PoE Both = PoE&Local Prim = Primary
2 = Class II N = Network Con. Locl = Local Unkn = Unknown Back = Backup
Local Neighbor Neighbor Neighbor System MED
Port Chassis ID Port Name Sys Name Cap. Cl Pwr
--------------------------------------------------------------------------------
1.0.2
0015.77cc.e242 1.0.12 --B-R---
1.0.3 c286.11bc.a7a4 1.0.16 --B-R---
Table 134. SHOW LLDP NEIGHBORS INTERFACE Command
Parameter Description
Local Port The local port that received the
information from the neighbor.
Neighbor Chassis ID The ID number of the neighbor’s chassis.