Allied Telesis AT-8100 Series - Manual (Page 818)

Chapter 55: STP Commands
818
SPANNING-TREE STP ENABLE
Syntax
spanning-tree stp enable
Parameters
None
Mode
Global Configuration mode
Description
Use this command to enable STP on the switch. You must designate STP
as the active spanning tree protocol on the switch before you can enable it
or configure its parameters. For instructions, refer to “SPANNING-TREE
MODE STP” on page 812.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 170 or “SHOW SPANNING-TREE”
on page 806
Example
This example enables STP on the switch:
awplus> enable
awplus# configure terminal
awplus(config)# spanning-tree stp enable