Allied Telesis AT-8100 Series - Manual (Page 1561)

1561
Chapter 99
ACL Commands
The Access Control List (ACL) commands are summarized in Table 190
and described in detail within the chapter.
Table 190. Access Control List Commands
Command Mode Description
“ABSOLUTE START” on page 1564 Configuration
Time Range Sets a time range for an associated
permit or deny statement.
“ACCESS-CLASS” on page 1566 Virtual Terminal
Line mode Assigns an ACL to a VTY line.
“ACCESS-GROUP” on page 1568 Port Interface Adds IP ACLs to ports.
“ACCESS-LIST (MAC Address)” on
page 1570 Global
Configuration Creates ACLs that identify packets
based on source and destination MAC
addresses.
“ACCESS-LIST ICMP” on page 1573 Global
Configuration Creates ACLs that identify packets
based on ICMP source and
destination IP addresses.
“ACCESS-LIST IP” on page 1576 Global
Configuration Creates ACLs that filter packets based
on source and destination IP
addresses.
“ACCESS-LIST PROTO” on
page 1580 Global
Configuration Creates ACLs that identify packets
based on protocol numbers and
source and destination IP addresses.
“ACCESS-LIST TCP” on page 1585 Global
Configuration Creates access control lists that filter
ingress packets based on TCP port
numbers.
“ACCESS-LIST UDP” on page 1589 Global
Configuration Creates access control lists that
identify ingress packets based on
UDP port numbers.
“IP ACCESS-LIST” on page 1593 Global
Configuration Creates a Named IP ACL and enters
the IP ACL mode.
“IP ACCESS-LIST (ICMP)” on
page 1594 IP ACL Defines an ACL that filters ICMP
packets based on source and
destination IP addresses.