Allied Telesis AT-8100 Series - Manual (Page 1865)

1865
Chapter 107
Routing Information Protocol (RIP)
Commands
The RIP commands are summarized in Table 258 and described in detail
within the chapter.
Table 258. RIP Commands
Command Mode Description
“AUTO-SUMMARY” on page 1868 Routing
Configuration Activates automatic route
summarization.
“DEFAULT-INFORMATION
ORIGINATE” on page 1869 Routing
Configuration Configures the switch to send its
default route from the RIP-enabled
routing interfaces.
“IP RIP AUTHENTICATION STRING”
on page 1870 VLAN Interface Specifies an authentication key or
password that a routing interface uses
to authenticate the routing updates.
“IP RIP AUTHENTICATION MODE”
on page 1871 VLAN Interface Specifies the MD5 or plain-text
authentication mode for an
authentication key or password on a
routing interface.
“IP RIP RECEIVE-PACKET” on
page 1872 VLAN Interface Enables the VLAN interface to receive
routing updates.
“IP RIP RECEIVE VERSION” on
page 1873 VLAN Interface Specifies the version of routing
updates accepted on the VLAN
interface.
“IP RIP SEND-PACKET” on
page 1875 VLAN Interface Enables the VLAN to send routing
updates.
“IP RIP SEND VERSION” on
page 1876 VLAN Interface Specifies the version of routing
updates that the VLAN interface
sends.
“IP RIP SPLIT-HORIZON” on
page 1877 VLAN Interface Activates split-horizon or split-horizon
with poison reverse on the routing
interfaces.
“NETWORK” on page 1879 Routing
Configuration Specifies a network or VLAN to allow
the interface to send and accept
routing updates.