Allied Telesis AT-8100 Series - Manual (Page 332)

Chapter 14: IPv4 and IPv6 Management Address Commands
332
SHOW IP ROUTE
Syntax
show ip route
Parameters
None
Mode
Privileged Exec mode
Description
Use this command to display the routes on the switch. Figure 73 displays
an example of the information.
Figure 73. SHOW IP ROUTE Command
The fields are described in Table 29.
--------------------------------------------------------------------
Destination Mask NextHop Interface Protocol
--------------------------------------------------------------------
192.168.1.0 255.255.255.0 192.168.1.1 vlan1-0 INTERFACE
--------------------------------------------------------------------
Table 29. SHOW IP ROUTE Command
Parameter Description
Mask The masks of the management IP
address and the default gateway address.
The mask of the default gateway is
always 0.0.0.0.
NextHop The management IP address and the
default gateway address. The
management IP address is the first entry
in the table, and the default gateway
address is the second entry.
Interface The VID of the VLAN to which the
management IP address is assigned.