No network, No network 0 – Allied Telesis AT-8100 Series User Manual
Page 1890
Chapter 107: Routing Information Protocol (RIP) Commands
1890
NO NETWORK
Syntax
no network network-address|subnet-mask|vlanid
Parameters
network-address
Specifies the network address to remove.
subnet-mask
Specifies the subnet mask of the network address. This parameter
is optional. When no mask is entered, the switch applies a mask
based on the class (A, B, or C) of the entered network address. For
example, the switch gives an IP address of 10.0.0.0 to a prefix
length of 8.
vlanid
Specifies the ID number of a VLAN.
Mode
Router Configuration mode
Description
Use this command to remove the specified network or VLAN from the RIP
routing process and stop the network or VLAN from sending and receiving
routing updates:
Confirmation Command
Example
The following example removes VLAN 2 from the RIP routing process and
stops VLAN 2 from sending or receiving routing updates:
awplus> enable
awplus# configure terminal
awplus(config)# router rip
awplus(config-router)# no network vlan2