Allied Telesis AT-8100 Series - Manual (Page 526)

Chapter 32: Group Link Control Commands
526
GROUP-LINK-CONTROL
Syntax
group-link-control group_id
Parameter
group_id
Specifies the ID number of a new group. The range is 1 through 8.
You can create only one group at a time.
Mode
Global Configuration mode
Description
Use this command to create new groups for group link control. To add
ports to groups, refer to “GROUP-LINK-CONTROL DOWNSTREAM” on
page 527 and “GROUP-LINK-CONTROL UPSTREAM” on page 529.
Use the NO form of this command to delete groups.
Confirmation Command
“SHOW GROUP-LINK-CONTROL” on page 533
Example
This example creates a group with the ID 1:
awplus> enable
awplus# configure terminal
awplus(config)# group-link-control 1