Allied Telesis AT-8100 Series - Manual (Page 759)

759
Chapter 52
LACP Commands
The LACP port trunk commands are summarized in Table 87 and
described in detail within the chapter.
Table 87. LACP Port Trunk Commands
Command Mode Description
“CHANNEL-GROUP” on page 760 Port Interface Creates new aggregators and adds
ports to existing aggregators.
“LACP SYSTEM-PRIORITY” on
page 762 Global
Configuration Sets the LACP system priority value
for the switch.
“NO CHANNEL-GROUP” on
page 763 Port Interface Removes ports from aggregators and
deletes aggregators.
“PORT-CHANNEL LOAD-BALANCE”
on page 764 LACP Port
Trunk Interface Sets the load distribution method.
“SHOW ETHERCHANNEL” on
page 766 Privileged Exec Displays the ports of the aggregators
on the switch.
“SHOW ETHERCHANNEL DETAIL”
on page 767 Privileged Exec Displays the states of the ports of the
aggregators.
“SHOW ETHERCHANNEL
SUMMARY” on page 769 Privileged Exec Displays detailed information about
the aggregators.
“SHOW LACP SYS-ID” on page 770 Privileged Exec Displays the LACP priority value and
MAC address of the switch.
“SHOW PORT ETHERCHANNEL” on
page 771 Privileged Exec Displays the LACP port information.